FT1000

OUT OF BAND MOD

1. REMOVE POWER AND ANT.
2. OPEN CASE TOP AND BOTTOM.
3. LOCATE FOUR SCREWS ATTACHING FROUNT PANEL AND REMOVE THE TOP SCREWS.
   LOOSEN THE BOTTOM SCREWS.
4. TILT FROUNT PANEL FORWARD.
5. ON THE LEFT SIDE OF THE RADIO, REMOVE THE PLUG FROM POWER SUPPLY TO
   THE FROUNT PANEL. (GRAY AND WHITE WIRES.)
6. LOCATE THE JUMPER POSITION 3 ON CONTROL BOARD.
7. CHANGE THE JUMPER STATUS IN POSITION 3.
8. REASSEMBLE RADIO.
9. RESET CPU.

Msg Nr.     : 160374
Da          : EA7FHR
Per         : MODS  @WW      
Tipo/status : BF
Data/ora    : 0305/0144
Dimensione  : 2493
Bid (Mid)   : 21959_EA7FKB
Titolo      : Alcune modifiche per l'FT1000

I received a mail from AA6SQ about Extended transmitter frequency range
for FT990 and FT1000
-Remove top and bottom covers. Remove top screw on each side which holds
front panel to chassis. Pivot front panel down slowly. CAUTION : if you
let it go, it will flop down rapidly and probably tear somethins loose. 
Behind the meter will be the CNTL unit. It has a metal cover about 4 * 8
inches. Snap the cover off. Look to the top of the unit. You will see
JP-3. Remove the solder connection on JP-3.
Best 73 and good traffic on HF bands . Bert fF6HKA
=========================================================================
Note: I haven't tried or verified this, proceed at your own risk.  And
do not transmit outside of legal bands!  WA2ISE


  73S DE JERONIMO   EA7FHR @EA7FKB.EAA.ESP.EU. Copied from the QRZ! Windows Ham Radio CDROM